xlobby & ocelot

[RAKY0311]

Can I use xlobby for front end for the ocelot controler?in this way tou can use for control IR, X-10 and create macros. thanks

[hjackson]

Does Ocelot have a commandline interface?

hjackson

[Heiko]

The Adicon-Software does'nt support a command line interface. I think the best way to have access to the ir-functions of the ocelot, is to use the homeseer 2-way ocelot interface. For a XL-connectivity we have to wait for the xAP-plugin. Seee this thread:
http://www.xlobby.com/forum/viewtopic.php?t=2100

[kjheu]

There is a ocelot plugin for girder that allows girder to communicate to the ocelot over the serial port.

Ocelot Girder Plugin
====================

Overview
--------

A plugin for Girder that allows an ADI Ocelot or Leopard home
automation controller to generate events and respond to commands
without the need for complicated programming on the controller.

Features
--------

Generates Girder events in response to the following:

- X10 device status changing
- X10 commands sent/received on all house codes:
- Device on/off command pairs
- On/off
- All lights on
- All lights off
- All units off
- Dim
- Bright
- A recognised infra-red signal received

Can be configured to perform the following commands as Girder actions:

- Send X10 commands
- Send IR signals (both local and via SECU-16IR)
- Set variable values
- Set timer values

Interfaces with the Lua scripting language

[RAKY0311]

yes!!!

[RAKY0311]

are some way to make a xlobby page to check the status of the x-10 devices? ...also,thanks for the reply's

[SteveK]

are some way to make a xlobby page to check the status of the x-10 devices? ...also,thanks for the reply's

The plug-ins author is planning to add this feature very soon. I'll post again when the new plug-in is ready.