Delta 410.....how to sync all 4 stereo outputs?..PARTY zone?

[jcrack_corn]

Ok.....i'm now trying to set up the 410's multi out feature to use ONE instance of winamp to send audio to all 4 sets of analog outputs..

In winamp, I select Delta Multi as my device (using Directsound).

it only outputs on channels 1/2 though.....no mixer levels in the other channels.....

Am i missing something????


(and i can select each set, 1/2, 3/4, 5/6, 7/8, individually and get sound, so it is not an amp/speaker problem.....for some reason the 410 is splitting the input to all the channels???)

[jcrack_corn]

Best way i can figure to do this now is to patch onboard audio to delta 410 IN, and then mix that to the outputs.....

Works fine, but of course requires that duing parties, I manuall change the delta mixer settings (10 seconds)....

Anychance of a plugin or other workaround to push an xlobby "button" and have it macro out those changes????

(ie, push "party", it would change the delta's 5 outputs to H/W In.....push party off, it would chnage them back to wave in).....??? Seems simple enough, i will look into it.....

[scottw]

Have you checked out the Output Stacker for winamp:
http://forums.winamp.com/showthread.php?threadid=207987&highlight=output+stacker
You can find it on the 6th post down.

Also check here:
http://www.xlobby.com/forum/viewtopic.php?t=3714&postdays=0&postorder=asc&highlight=stacker&start=18

Hope that helps!!!